FRP Cooling Tower

FRP Cooling Tower

Mahakal Cooling Towers

Mahakal Cooling Towers offers FRP Cooling Tower. Square type cooling towers operates according to the counter flow principle. The water to be cooled is connected into the tower at the top in main header pipe and is distributed by branch pipes with splash cap (nozzles) with a low pressure drop, and flows down, in the form of a thin water film and small droplets, over the largest possible fill surface for the heat transfer. The water falls through the fill and is collected in a FRP basin at the bottom of the tower. The atmospheric air is sucked in through the opening for air inlet on all sides at the lower portion of the tower and moves up through the PVC fill. The air moving up cools the falling water. Here the transfer of heat takes place by evaporation and direct contact. The air inlet is covered by PVC Mesh for free flow of air. Advantage: )Energy efficient - use of high efficient fill, and nozzles with a low pressure drop, Durable - use of high quality materials, Guaranteed performance - use of PVC fill, Aesthetic looks - use of FRP panels.

Add to MyIPF

  • Casing, Basin, Fan deck and Fan stack in corrosion-resistant and fire-retardant FRP
  • Hot dip galvanized supporting structural.
  • Fill material of PVC (max. temp. 60 Degree C).
  • High efficient axial flow Fan with Aluminium / FRP blades and cast aluminum alloy hub.
  • Drift eliminators of PVC extruded ‘C’ & ’S’ type (drift percentage shall not exceed 0.05 of circulating water flow).
  • Water distribution system with PVC pipe and PP splash cap (nozzles).

Products from Mahakal Cooling Towers

PVC Fills Cooling Tower PVC Fills Cooling Tower
Cooling Tower Drive Shaft Cooling Tower Drive Shaft
Cooling Tower Control Valve Cooling Tower Control Valve

Products from MACHINE TOOLS, POWER & HAND TOOLS Category

Perforated Metal Facades Perforated Metal Facades
Rotary Broaching Tool Rotary Broaching Tool
Polygon Turning Machine - TPT-5S, TPT-5ST Polygon Turning Machine - TPT-5S, TPT-5ST