Grind Master, a leading manufacturer of automatic machines for deburring, polishing, microfinishing & robotic deflashing of castings, will showcase a range of latest machines at IMTEX 2019.
At the expo, the company will exhibit products such as gear tooth chamfering & deburring machine (RCD 160); Centerless Throughfeed Superfinisher (CST600); longitudinal polishing machine for round tubes (LPH Series); turnkey solution for finishing steering rack bars (NF1000MP); precision deburring machine (CF Series); grinding machine for large diameter tubes, billets & rollers (FT400); and next-generation flexible microfinishing machine for automotive powertrain parts (Supramatic CMX500).
Grind master offers gear tooth chamfering and deburring machine in technical collaboration with Samputensili, Italy. Model RCD 160 is a universal machine which can be used for a wide range of spur and helical gears, shaft type gears, bevel gears and pinions etc. It has chamfering and deburring heads that use patented forming tooling from SAMP. It is an user-friendly machine with NNANOFINISH control system and part type selection through HMI.
CST600 is engineered for high quality finishing of pin-type parts (cylindrical) like crank pins, shock absorber piston rods, pistons of piston pumps, bearing cartridges, plunger of fuel systems etc. CST600 uses reliable tape finishing technology which is much more user friendly and fit & forget type of system compared to conventional stone technology. Consequently there are several savings in terms of energy and reductions in rejection.
Grind Master offers LPH series machine for polishing round tubes and bars of stainless steel & aluminium to generate bright glossy finish. This machine can be installed in line with other tube polishing machines.
Grind Master Nanofinish Series NF1000MP machine has multiple workstations with a combination of inline crack detection system and two stations of super-finishing for high speed processing of rack bars. The entire system is controlled with NANOSMART Controller which includes automatic load/unload, remote asset management system, wrong part detection and other IoT features.
Grind Master offers a wide range of conveyorised belt grinding and brushing machines which are used for deburring of flat punched and fine blanked parts like clutch plates, discs, sector gears, brake pads, bearing thrust washer etc. These machines are offered with multiple belt grinding heads and planetary brushing heads depending on the amount of burr and customer requirement of deburred edge and finish. The new platen type belt grinder ensures the flatness on the parts. The machine can deburr even non-magnetic small parts. This process improves the surface contact area of flat parts which is important for parts like engine thrust washers.
Grind Master’s FT series machine is used for grinding & finishing of large billets, rollers, cylinders & tubes. Machine can be used for jobs with diameter 130 mm to 400 mm and length of 1600 mm to 3600 mm. Machine has job support on rollers and belt grinding heads move along the length. The heads are specially designed to take care of out of roundness on the job.
Supramatic CMX500 is a next generation microfinishing machine highly flexible for automotive powertrain parts including crankshafts, camshafts, gearbox shafts and steering racks. The France-based SPMS Supramatic, a strategic partner of Grind Master, is well known over a 45 years period for building super-finishing machines that are installed in auto OEMs. The CMX500 is a next generation machine built with advanced control system that is IoT enabled and ultra-user friendly with tool management system, voice guidance, connection to smartphone, Rams for data logging and monitoring. The machine has modular configuration with flexibility to set it up for various parts, automatic changeover between crankshafts, camshafts, gearbox shafts.
For details, contact Grind Master on Tel: 0240 237 4104, 237 4114 or email: firstname.lastname@example.org, or visit www.grindmaster.co.in